Table of Contents
Advertisement
Installation instructions
3.7 Adjustment of rotating table
Floor of the machine showing rotating table and floor plates
1.
2.
3.
4.
5.
•
•
•
•
•
•
•
2
2
1
D335_1
Rotating table
Support rollers
Sill plate
Location of support legs
Rotating table start position markers
After installing the machine, the rotating table (1) needs to be adjusted to
the correct level. This is done using the two support legs, which are located
under the machine at (4).
If the machine is mounted on a stand, check that the stand is adjusted to
the correct height and that the machine is horizontal.
Check that both sill plates (3) are in place.
The rotating table (1) must be in its start position. The markers (5) on the
rotating table and sill plate should now be exactly aligned.
Adjust the support legs though both holes at (4). There is a nut welded to
the top of each leg. Use a ratchet spanner to adjust the legs to the correct
position. Turn to the right to screw the legs downwards and to the left to
screw them upwards. Screwing the legs to the right or left raises or lowers
the rotating table.
Check under the machine to ensure that the legs are touching the floor. If
the machine is recessed into the floor, remove the cover plates around the
machine to check the legs.
If the rotating table (1) is adjusted to the correct position, the top of the
rotating table should be at the same level as the top of both the sill plates
WD-18CW
18
Rev. (202211)
3
2
4
2
3
5
Advertisement
Table of Contents
