Preparations Before Filling; Filling And Heating The Machine - Wexiodisk WD-6 Installation And User Manual

Operating instructions

4.1.2 Preparations before filling

Check:
•
•
•
•
•
•
Detergent and drying agent
•
•
•
•
•
•

4.1.3 Filling and heating the machine

•
•
•
•
WD-6
That the machine and removable parts have been cleaned. If not – clean
them!
that no dirt is in the washer arms' (18) or in the rinse pipes' (10) nozzles
That removable parts are correctly in place
the amount of detergent and drying agent
That the stopcock for the water to the machine is open
That the power switch is in the ON position
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable deter-
gent. Washing-up liquid causes a build-up of foam, produces poor wash re-
sults and can damage the machine.
Steel wool must not be used for pre-treating the dishware.
Only detergent and drying agent intended for industrial machines may be
used.
If using liquid detergent and drying agent, the same make and type of de-
tergent and drying agent should be used.
If the machine is designed for glass washing and equipped with a condens-
ing unit, detergent intended for aluminium should be used.
If the machine is equipped with a condensing unit, dishware should be re-
moved from the machine as soon as the condensation cycle is complete so
that re-condensation does not occur.
Switch on the power using the 0/1 button (9) on the panel. The display (3)
shows the temperature of the rinsing water. The other display (4) shows
"P0". P0 is a pause mode which indicates that no washing programme has
been selected.
Close the hood and the machine will start to fill. Filling and heating for a
standard machine takes approx. 6 minutes at an incoming water tempera-
ture of 55°C. The heating time is dependent on the incoming water temper-
ature.
Once the machine is full, the symbol (1) lights up and the display (2) shows
the temperature of the washing water. If the washing temperature falls be-
low the set value by more than 5°C, the temperature shown on the display
(2) flashes.
The machine cannot start washing until the set temperature minus 5°C for
the washing water has been reached, if this function is selected. The nor-
mal operating temperature for the washing phase is 60°C. When the wash-
ing temperature falls below 50°C, the temperature display flashes.
33
Rev. 6.0 (201902)