Electrical Connection; Water Connection, Regardless Of Any Options - Wexiodisk WD-6 Installation And User Manual

Installation instructions
1.
2.
3.
4.
5.
6.
7.
8.
In the following chapter, figures are given in brackets to clarify what needs to be
done. These numbers refer to image and list above.

3.5.1 Electrical connection

Information about electrical connections is available on the machine's wiring dia-
gram which is provided on delivery. Store the diagrams in the plastic pocket, lo-
cated in the electrical cabinet, even after installation.
•
•
After completing the installation, switch on the main switch and all circuit break-
ers.

3.5.2 Water connection, regardless of any options

•
•
The water pipe is connected at (2) or at (7). If the machine is connected with a
hose, this should be steel braided and have an internal diameter of at least 12
mm.
The hot water connection on the machine is fitted with a filter.
As the machine is fitted with a "Break Tank", the connection is fitted with a filter
and non-return valve.
WD-6
Electrical connection
Water connection
Drain/waste pipe connection
Plugged hole for detergent hose
Bleed for lifting cylinder (on machines with an automatic hood)
Water pressure outlet for detergent dosage
Alternative water connection from below
Drain connection (optional)
The machine is designed for quick electrical installation.
The machine must be connected to a lockable main switch. This should be
placed on a wall, well-protected from water and from the steam which es-
capes when the machine is opened. The machine is supplied with the elec-
trical cable connected (1).
A shut-off cock must be installed on the incoming pipe.
It is important that the water supply has sufficient pressure to ensure the
correct flow of water to the machine. The required water flow and pressure
can be found in the TECHNICAL SPECIFICATIONS. If the water pressure
is too low, a booster pump must be fitted.
13
Rev. 6.0 (201902)