Operating Problems - Wexiodisk WD-6 Installation And User Manual

Operating instructions

4.3.6 Operating problems

Error messages
During operation, various alarms or information messages can appear on the
panel's display. There is a distinction between IF and Er alarms. IF alarms can
normally be dealt with by the operator. If there is an Er alarm, the service person-
nel must be called. Some IF alarms that have been dealt with by the operator a
few times will eventually change to Er alarms, meaning that the service personnel
must be contacted.
Each alarm has a number: 01, 02, 03 etc. The top display shows either IF or Er.
The bottom display shows the alarm number.
CODE CAUSE
IF01 / The time needed to fill the tank has been
Er01 exceeded.
The level pipe is not in place.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
The water stopcock is closed.
Er02 It has taken too long for the machine to
heat up, compared with the previous
time.
Er04 Faulty temperature sensor.
Er05 Faulty temperature sensor.
IF06 / The booster heater is not cooled during
Er06 the final rinse phase.
The water stopcock is closed.
IF09 Alarm for changing the water.
IF10 Alarm for weekly cleaning.
Er12 The break tank has not filled with water.
Er16 The temperature in the booster heater is
too low.
Er23 The hood does not open when the auto-
matic hood opener is used.
Er27 The machine has lost all its set values.
IF30 Low water level in the washing tank be-
fore washing.
The level pipe's rubber sleeve is leaking.
IF34 The detergent alarm.
The machine has run out of detergent.
IF35 The machine is started with the hood
closed.
WD-6
ACTION
The alarm can be reset by pressing 0/1 on the panel.
Fit the level pipe.
Adjust the level pipe. Check that the rubber sleeve has not
been damaged. Replace the sleeve, if it is damaged.
Open the stopcock.
The alarm can be reset by pressing 0/1 on the panel. Con-
tact service personnel if the alarm recurs.
Contact service personnel.
Contact service personnel.
The alarm can be reset by pressing 0/1 on the panel.
Open the stopcock. Close the door.
Change the water. The alarm can be reset by pressing 0/
1 on the panel. If the alarm is not set to stop the machine,
the washing programme can continue.
The machine must be cleaned more thoroughly than dur-
ing daily cleaning. The alarm can be reset by pressing 0/
1 on the panel.
The alarm is reset automatically when the tank is full.
The alarm can be reset by pressing 0/1 on the panel. Con-
tact service personnel.
The alarm can be reset by pressing 0/1 on the panel. Con-
tact service personnel if the fault recurs.
Contact service personnel.
Check that the level pipe is closed. The alarm can be re-
set by pressing 0/1 on the panel.
Check that the level pipe's rubber sleeve has not been
damaged.
The alarm can be reset by pressing 0/1 on the panel.
Check the amount of detergent and refill, if necessary.
Open and close the hood to acknowledge the alarm.
48
Rev. 6.0 (201902)