Wexiodisk WD-6 Installation And User Manual page 21

Installation instructions
• There is a plugged hole for a detergent hose on the back and end of the
machine (4).
• The detergent hose is connected to the pipe (A) at the top of the chemical
washing tank on the right-hand side (see the figure below). There is a con-
nection nipple in the pipe (B).
• If detergent paste is being used, the connection nipple must be removed
and the hose connected directly to the pipe (A).
• If liquid detergent is used, the nipple must be left in the pipe. Drill a hole
through the nipple and connect the hose to the nipple.
• The measuring cell for measuring the concentration of detergent in the
washing water must be put in the bottom of the tank. On the inside bottom
of the tank next to the heating element, the letter "C" is stamped into the
metal to mark where the hole should be drilled.
• The water outlet for detergent (6) is on the incoming water pipe (2).
When drilling holes, it is important that the following points should be observed:
• Use sharp tools so that panels do not become unnecessary hot. Red-hot
panels can rust in the future.
• Remove all metal shavings carefully both from the machine and tank be-
fore refilling with water. Shavings left in the tank can cause corrosion.
Connecting the detergent hose
Marking for measuring cell
A=Connection in the tank
B=Connection nipple
C=Marking in bottom of tank for measuring cell
For information about electrical connections, see the electrical diagram.
If equipment for a different type of detergent is used, it should preferably be put
on the wall behind the machine to avoid holes being drilled unnecessarily in the
machine.
The machine can also be equipped with detergent and drying agent equipment
via external connections. See the electrical diagram for correct connection.
The process of setting the detergent and drying agent dispenser is described in
the ADJUSTMENT INSTRUCTIONS.
WD-6
B
A
C
6D_tank
17
Rev. 6.0 (201902)