Steam Hood With Extractor (Optional) - Wexiodisk WD-6 Installation And User Manual

Installation instructions

3.5.11 Steam hood with extractor (optional)

Steam hood with extractor
1. Existing screws
2. Steam hood
3. Bracket
4. Connection for ventilation ø 160 mm
• Undo the existing M4 screws at (1).
• Replace the existing screws and washers with the longer M4 screws and
the larger washers provided. The steam hood (2) is fastened to (1) using
these screws.
• Screw one bracket (3) firmly to the wall behind the machine. The other
bracket must be put in the corresponding position on the back of the steam
hood. Two holes 7 mm in diameter must be drilled through the plate.
• Screw both the brackets (3) together with the screws, washers and nuts
provided.
• The ventilation duct is connected to (4).
WD-6
4
1
24
Rev. 6.0 (201902)
3
2
45089