Operating instructions
4.2.6 Changing the water
To achieve the best possible washing results, it is important that the water is
changed frequently. For normally soiled loads, the water should be changed after
around 50 washes. However, always change the water in the event of foam prob-
lems in the tank.
If IF09 appears on the display, this indicates that the water should be changed.
Machines without a drain pump
•
•
•
•
•
•
•
Machines with a drain pump (option)
NB: The hood/door must be open when the drain pump is running.
•
•
•
•
•
•
•
•
•
WD-6
Check that the machine is in P0 mode.
Open the hood.
Remove the tank filter (12) and clean it.
Empty the machine by turning the level pipe (13) anticlockwise.
When the tank is empty, turn the level pipe (13) clockwise and refit the tank
filters (12).
Check that the final rinse symbol (3) is lit.
Close the hood and the machine will refill.
Check that the machine is in P0 mode.
Open the hood.
Remove the tank filter (12), level pipe (13) and clean it.
Press the 0/1 button (9).
Press P1 (6) to start the drain pump. "dP" appears on the display (2).
When the tank is empty, refit the level pipe (13) and the tank filters (12).
Press the 0/1 button (9).
Check that the final rinse symbol (3) is lit.
Close the hood and the machine will refill.
43
Rev. 6.0 (201902)