Wexiodisk WD-6 Installation And User Manual page 55

Operating instructions
PROBLEMS
The machine is not cleaning
properly.
The dishware has tipped over in
the baskets.
Dishware does not dry.
When you contact service personnel, you will need to provide the following infor-
mation:
•
•
•
•
WD-6
CAUSE
The rinse and wash nozzles are
clogged with dirt.
There is too little detergent.
The water in the tank is too dirty.
Foam forming in tank.
Programme with too short a washing
time selected.
Dirt has dried on the dishware to be
washed.
The dishware is incorrectly posi-
tioned in the baskets.
Detergent and drying agent of anoth-
er make than usual are used.
The dishware is incorrectly posi-
tioned in the baskets.
Light dishware need washing.
The rinse nozzles are blocked.
Too little rinsing agent.
The washed items have been left in
the machine.
Machine type and model.
Machine serial number and date when the machine was installed.
A brief description of the problem. Are any fault codes shown in the dis-
play?
What happened/was being done immediately before the fault occurred?
51
Rev. 6.0 (201902)
ACTION
Check and clean the nozzles.
Check the amount of detergent. The
hose ("coarse") must be submerged
in liquid and the filter in the hose
must be clean.
Change the water.
Check that the washing temperature
is not too low and that the correct de-
tergent is being used.
Choose a wash programme with a
longer washing time.
Soak the dishware before washing.
Use the correct type of washing bas-
ket and accessories to ensure that
the dishware is correctly positioned.
Use the same make and type as be-
fore. If necessary, rinse hoses and
pumps with water.
Put the dishware in the correct posi-
tion.
Use a net grid to hold the items.
Check and clean the nozzles.
Check the amount of rinsing agent.
The hose ("thin") must be sub-
merged in liquid and the filter in the
hose must be clean.
Remove the washed items once the
programme has ended.