Beechcraft C-12C Operator And Technical Reference Manual page 169

3. If desired, the right inner knob may
be pushed back in and more
characters added to the name.
4. When complete, push the right
inner knob in and press the CRSR
button to turn off the cursor
function.
(c) There are a few changes made to
names in order to accommodate the KLN 90B display.
Names that are too long to fit on the display are
abbreviated. The first six characters are usually
exactly correct, with some exceptions. Refer to Table
3-3 for a list of exceptions.
Table 3-3. Abbreviations
North, Northern, East, Eastern, etc.
Southeast, Northwest, etc.
Point
Port
Fort
Saint
International
Regional
General
1. Person's name – Uses initials for
other than last name unless very
well known (Will Rogers).
2. Delete "City of" (City of Colorado
Springs).
3. Delete "Greater" (Greater Buffalo).
4. Delete "The."
(d) Unless the first word is greater than
eight characters, it is usually not abbreviated.
(e) Delete most punctuation such as
period and apostrophes.
(f) Abbreviations for International are
INTL, INT, and IN.
(g) Abbreviations for Regional are REGL
and REG.
k. DIRECT TO Operation. The D
used to initiate navigation from the present position
direct to a waypoint. When the D
the Direct To page, Figure 3-8, will be displayed on the
left side with a flashing cursor over a waypoint
identifier. The waypoint identifier that appears on the
Direct To page is chosen by the KLN 90B according to
the following rules.
the left side and the cursor is over one of the waypoint
identifiers in flight plan 0 when the
pressed, then that waypoint identifier will appear on
the direct to page.
N, E
SE, NW
PT
PT
FT
ST
INTL, INT,
IN
REGL, REG
NAV 5 page and the right inner knob is in the "out"
GEN
position, then the waypoint highlighted in the lower
right hand corner of the super NAV 5 display will be
the default waypoint.
VOR, NDB, INT, SUP, or ACT page) in view on the
right side when the
Direct To page will contain the identifier of the
waypoint being viewed on the right side.
number 3 above are occurring, then:
waypoint identifier for the current active waypoint will
be displayed. However, if the active waypoint is the
missed approach point and the aircraft is passed the
missed approach point, then the KLN 90B will display
the first waypoint of the missed approach procedure
on the Direct To page.
D
displays blanks. In order for there not to be an active
button is
(1) If the flight plan 0 page is displayed on
DIRECT TO:
KDEN
CRSR
Figure 3-8. Direct To Page
(2) If the KLN 90B is displaying the super
If condition number 1 or 2 isn't occurring:
(3) If there is any waypoint page (APT 1-8,
D button is pressed, then the
If none of conditions number 1, number 2, or
(4) When the D
(5) If there is no active waypoint when the
button is pressed, then the Direct To page
TM 1-1510-218-10
button is pressed,
D button is
button is pressed, the
3-15