Beechcraft C-12C Operator And Technical Reference Manual page 233

for navigation. Insufficient number of satellites or
inadequate satellite geometry to accurately determine
the position within 3.8 nm.
(43) SET FUEL ON BOARD ON OTH 5 IF
NECESSARY - Appears when the KLN 90B is
interfaced with a fuel flow computer that allows the fuel
on board to be set.
(44) SYSTEM TIME UPDATED TO GPS
TIME - Appears when the KLN 90B system time is
automatically updated to GPS time by more than
10 minutes.
(45) USER DATA LOST - Appears when the
unit determines that the internal memory backup
battery is dead or that some other internal failure has
occurred which has caused all user entered data to be
lost.
(46) VNV ALERT - Appears when a VNAV
operation has been programmed on the NAV 4 page
and the estimated time to start the climb or descent is
approximately 90 seconds.
(47) WAYPOINT ___ DELETED - Appears
when a waypoint used in a flight plan, or the active
waypoint, no longer exists as a result of updating the
database. The waypoint is deleted from flight plans in
which it was used.
(48) WPT ANNUNCIATOR
message displays when there is a failure of the KLN
90B WPT annunciator drive circuitry. To determine if
waypoint alerting is being given, check the display of
the KLN 90B.
bj. Status Line Messages.
operational messages that are displayed in the lower
center segment of the screen.
(1) ACTIVE WPT - Appears if an attempt is
made to delete a waypoint on the OTH 3 page and the
waypoint is the active waypoint.
(2) D CRS XXX° - Appears when the KLN
90B is in the OBS mode and is interfaced with an
external indicator which the KLN 90B cannot change
the selected course and the pilot performs a direct to
operation. Since the KLN 90B cannot change the
selected course, the pilot is given a message for the
OBS value to set the indicator to.
(3) DUP IDENT - More than one waypoint of
that type has the same identifier.
(4) ENT LAT/LON - A reminder to enter the
location of a user-defined waypoint.
to add a waypoint to a flight plan that already contains
30 waypoints.
defined VOR is the active waypoint and attempt is
made to change the stored magnetic variation of this
VOR.
while the VOR is the active waypoint.
attempt is made to add a waypoint to an approach.
is made to delete a waypoint from an approach.
is made to enter invalid data, e.g., 30 FEB 96.
to create an invalid reference waypoint.
waypoint identifier has been entered on the NAV 4
page if the waypoint is not valid for VNAV operation.
attempt to activate the OBS mode if there is no active
waypoint.
FAIL - This
attempt to arm the GPS approach mode when there is
no approach loaded into the active flight plan.
type pages have been selected if the KLN 90B doesn't
contain a database cartridge and there are no user-
These are short,
defined airport waypoints.
type pages have been selected if the KLN 90B doesn't
contain a database cartridge and there are no user-
defined intersection waypoints.
attempt is made to recalculate the intercept point on a
DME arc and the actual track doesn't intercept the arc.
type pages have been selected if the KLN 90B doesn't
contain a database cartridge and there are no user-
defined NDB waypoints.
no waypoint in the database corresponding to the
identifier entered on the reference waypoint page.
(5) FPL FULL - An attempt has been made
(6) IN ACT LIST - Appears when a user-
The magnetic variation cannot be changed
(7) INVALID ADD - Appears when an
(8) INVALID DEL - Appears when an attempt
(9) INVALID ENT - Appears when an attempt
(10) INVALID REF - Appears with an attempt
(11) INVALID VNV
(12) NO ACTV WPT - Appears with an
(13) NO APPROACH - Appears with an
(14) NO APT WPTS - Appears when the APT
(15) NO INT WPTS - Appears when the INT
(16) NO INTRCEPT - Appears when an
(17) NO NDB WPTS - Appears when the NDB
(18) NO SUCH WPT - Appears when there is
TM 1-1510-218-10
- Appears when a
3-79