Beechcraft C-12C Operator And Technical Reference Manual page 436

TM 1-1510-218-10
Figure 3C-27. Start 1 Position/Time Initialization
Table 3C-19. Start 1 Position/Time
Initialization Procedures
NO. DESCRIPTION/FUNCTION
1 Enter airport identifier in Scratchpad.
2 Press Left Line Key 1.
3 Verify the Lat and Long.
4 Verify UTC date, change as required.
5 Verify UTC time, change as required.
6 Verify current system datum.
7 Scroll to Start page 2.
2. If the initial date or time is incorrect,
enter the correct values. and continue
the initialization on the START page
2. Refer to Figure 3C-28 and
Table 3C-20.
IAW Army standardization programs and
policy, the GPS will be initialized upon
each power-up.
3C-82
NOTE
Figure 3C-28. Start 2 Navigation/Initialization
Table 3C-20. Start 2 Navigation/
Initialization Procedure
NO. DESCRIPTION/FUNCTION
1 Command GPS initialization.
2 Scroll to Start 3 page.
3. Scroll to the START
the effectivity date of the ICAO data
base is correct. Refer to Figure 3C-29
and Table 3C-21. If a new flight plan
and mission data are to be entered
manually, select ERASE FPLN. If a
new plan is to be loaded from the
cartridge, first enter the desired flight
plan number or access the Alternate
Flight Plan Catalog and select the
desired
confirmation – select twice).
loading is complete, select FPLN
REPLACE.
alternate flight plan data into the
active flight plan so that both plans are
identical at the beginning of the
mission.
/DATA LOAD to load all remaining
preplanned mission data, including the
radio presets, V/UHF HAVE QUICK II
MWOD's,
identifiers, and user waypoint and
markpoint lists.
3 and verify
page
flight plan (requires
After
This transfers
The crew may select FLT
FMT's, SINCGARS
the
net