are at HIGH IDLE before initiating the final approach.
Perform the following checks.
1. Power – As required.
2. FLAPS – Retract to APPROACH.
3. GEAR (Positive climb) – UP.
4. FLAPS (105 KIAS) – UP.
5. LANDING LIGHTS – OFF.
6. Climb power – Set.
7. YD – As required.
8. BRAKE DEICE – OFF.
8-44. AFTER LANDING.
Complete the following procedures after the
aircraft has cleared the runway.
1. CONDITION levers – As required.
2. ENG AUTO IGN – OFF.
3. ICE & RAIN switches – As required.
4. FLAPS – As required.
5. XPNDR – Standby.
6. RADAR – Standby.
7. LIGHTS – As required.
8-45. ENGINE SHUTDOWN.
To prevent sustained loads on rudder
shock links, the aircraft should be parked
with the nose gear centered.
1. BRAKE DEICE – OFF.
2. Parking brake – Set.
3. LANDING/TAXI light – OFF.
4. CABIN TEMP MODE switch – OFF.
5. AUTOFEATHER switch – OFF.
6. VENT and AFT VENT BLOWER switches
– AUTO.
NOTE
7. INVERTER switches – OFF.
8. Battery condition – Check as required. If
BATTERY CHARGE light is illuminated
during engine shutdown, turn BATT switch
OFF momentarily and note loadmeter
reading. After 90 seconds, momentarily
turn switch OFF again and note loadmeter
reading.
unsatisfactory if BATTERY CHARGE light
remains illuminated and charge current
fails to decrease between checks.
CAUTION
Monitor TGT/ITT during shutdown.
sustained
combustion
proceed
immediately
procedure, Paragraph 8-24.
9. TGT/ITT – Check.
660 qC or below for 1 minute prior to
shutdown.
10. CONDITION levers – FUEL CUTOFF.
11. PROP levers – FEATHER.
WARNING
Do not turn EXTERIOR LIGHTS off until
propeller rotation has stopped.
12. EXTERIOR LIGHTS – Off.
13. MASTER PANEL LIGHTS – Off.
14. AVIONICS MASTER switch – Off.
15. MASTER SWITCH – Off.
16. Key lock switch – OFF.
17. Oxygen system – OFF.
18. Chocks – As required.
19. Parking brake – As required.
20. Control locks – As required.
8-46. BEFORE LEAVING AIRCRAFT.
1. Wheels – Chocked.
TM 1-1510-218-10
Battery
condition
If
is
observed,
to
Abort
Start
TGT/ITT must be
8-23
is
Need help?
Do you have a question about the C-12C and is the answer not in the manual?