Control Panel; Preparing The Device - Atmos E 341 Battery Operating Instructions Manual

3.1.2 Control panel

LEDs for the display of the current vacuum
1
Display of battery status
2
Control button battery status
3
Button to select the desired vacuum
4
On/off button
5
Display of the battery status
The following display values are not valid during battery charging.
> 85 %
Prior to the battery going dead a signal tone sounds every 5 seconds.
An error is present if all the green LEDs flash simultaneously or all LEDs are flashing.
Please observe chapter „7.0 Eliminating errors" on page 47.

3.2 Preparing the device

Prior to first operation peruse the safety notes in chapter „2.0 Hints for your safety" on
page 11.
Damaged pump diaphragms due to cold temperatures during transport.
1. After transport in temperatures below -5°C: The device must be acclimatized for up
to 6 hours at room temperature before you continue with the next steps.
2. Check the device for any damage in transport.
3. If the device is damaged: Document and report the transport damage. Send in the
device to ATMOS (chapter „6.3 Sending in the device" on page 44).
4. If the device is not damaged: Place it on a safe and even surface.
5. Check the charging accessories for any damage.
6. Replace defective charging accessories immediately.
7. The battery must be fully charged, chapter „3.3 Charging the battery" on page 17.
8. Remove the canister system from the support.
9. With DDS canister system: Prior to first use, clean the canister system and insert
a bacterial filter (chapter „5.0 Cleaning and disinfection" on page 35 as well as
chapter „3.4 Connection and removal of canister system and hoses" on page 18).
16 Setting up and starting up
1
5 4
60 - 85 % 35 - 60 %
2
3
Flashes
< 15 - 35 % < 10 - 15 %
Green
and red
LED flash
< 10 %