Battery Exchange - Atmos E 341 Battery Operating Instructions Manual

6.5 Battery exchange

NOTICE
Damage to the electronics due to the use of a third-party battery.
• Only use the original lithium-ionic battery 4IMR 19/66-2 BM18650Z3. This battery is
included in the scope of delivery and is available at ATMOS. The warranty claim shall
not be applicable if non-original spare parts are used.
Prerequisite: The support for canister system is removed.
1. Switch off the device.
2. Disconnect the device from the power supply.
3. Remove the hose rewind: Chapter „3.6 Hose rewind" on page 29.
4. Place the device on its back with the control panel facing upwards.
5. Press the battery compartment cover
6. Lift the battery compartment cover slightly and remove it from the upper guide.
The detent could break off due to the incorrect removal of the cable.
2
7. Remove the cable from the device by pressing the detent
plug and simultaneously pull the plug.
2
8. Remove the battery in the upwards direction.
9. Insert the new battery. Please observe that the shape of the battery compartment
corresponds to the shape of the battery and the symbol
socket in the battery compartment.
10. Plug in the connector of the battery cable to the socket in the battery compartment.
11. Stow the cables in the battery compartment so that they cannot be damaged by the
battery compartment cover.
12. Insert the battery compartment cover in the upper rail.
13. Slide the battery compartment cover to the right until it stops.
14. Press down the battery compartment cover.
15. Slide the battery compartment cover completely to the right.
16. Attach the hose rewind: Chapter „3.6 Hose rewind" on page 29.
17. Affix the support for the canister system: Chapter „3.4 Connection and removal of
canister system and hoses" on page 18.
18. Perform a function check.
from right a little towards the left.
1
1
2
of the plug against the
2
indicates towards the
Maintenance and service
45