Eliminating Errors - Atmos E 341 Battery Operating Instructions Manual

7.0 Eliminating errors

The ATMOS E 341 Battery was subjected to a thorough quality control in the factory.
®
Nevertheless, if a problem may occur you can possibly solve it yourself.
Recharging and battery status
Error indication
Device cannot be
recharged.
LED on the power supply
and recharging unit is not
illuminated.
When recharging the
battery 100 % cannot be
achieved. The charging
time can take up to 3
hours.
The bottom green and
the red LED on the
display of battery status
flashes and a signal tone
sounds every 5 s.
During switch on: All
LEDs of the display of
battery status flash for 5
s, a signal tone sounds.
All the green LEDs on the
display of battery status
flash permanently.
Possible cause
The plug from the
charging accessories is
poorly fitted.
Charging accessories
are defective.
Battery is not
connected properly.
Battery temperature
too high or too low.
Deep discharge of the
battery.
Defective electronics.
Defective power
supply and recharging
unit.
The mains plug is
poorly fitted.
Battery service life
is exhausted or the
battery is defective.
Wrong charging
accessories.
Battery is almost
completely
discharged.
Remaining battery
level is low.
A non-ATMOS battery
is used.
Remedy
1. Check the connection to the
mains supply.
1. Exchange charging accessories.
1. Check the plug connections in
the battery compartment.
1. After long-term use: Let the
device cool down.
2. Extreme ambient temperature:
Position the unit where
appropriate to a cooler or
warmer place.
1. Exchange the battery.
1. Send in the device for repair.
1. Exchange the power supply
and recharging unit.
1. Check the connection to the
mains supply.
1. Exchange the battery.
1. Only use the provided charging
accessories or an original spare
part.
1. Recharge the battery.
1. Perform a function check.
2. Exchange the battery.
1. Only use the provided battery
or an original spare part.
Eliminating errors
47