Digital Inputs, Logic Power Supply - Jetter JM-206-230 User Manual

JetMove 206B-230
7.6
Specification of Terminal X10
•
•
•
Jetter AG

Digital Inputs, Logic Power Supply

10-pin spring tension terminal (type ZEC 1,0/10-ST-3,5)
Diameter of the cable apt for connecting: 0.2 ... 1 mm
with bootlace ferrules in a plastic sleeve: 0.25 - 0.75 mm
Bladed screw-driver: 0.4 x 2.5 mm
Digitale Inputs, Logic Power Supply
Wiring Signal
Terminal
X10 at the
Amplifier
ENABLE Hardware
enable for
the power
supply of the
motor
(Input)
REF Reference
switch
(Input)
LIMIT + Positive limit
switch (input)
LIMIT - Negative
limit switch
(input)
7.6 Digital Inputs, Logic Power Supply
2
Operating Principle
• At this input, a high
signal is necessary for
power supply of the
motor (This signal must
have been applied
before carrying out the
software enable).
• A low signal de-
energizes the motor
immediately.
• Depending on the
parameter setting, this
input is used for
reference run.
• Depending on the
parameter setting, this
input is used as a
positive limit switch.
• Depending on the
parameter setting, this
input is used as a
negative limit switch.
(AWG 24 ... AWG 16)
2
(AWG 24 - AWG 18)
Specification
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low,
> 15 V high
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low,
> 15 V high
NC or NO contact
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low,
> 15 V high
NC or NO contact
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low,
> 15 V high
NC or NO contact
67