Sun Microsystems Sun Blade 150 Service Manual page 117

5. Slide the hard drive tray out of the chassis.
6. Place the new secondary hard drive onto the hard drive tray.
7. Turn the tray upside down on an antistatic mat.
Note – Before installing the hard drive into the system, verify that the drive's back-
panel mode-select jumper is set to "CS," "Enable Cable Select," or "Cable Select."
8. Using a No. 2 Phillips screwdriver, install the four screws that secure the drive to
the hard drive tray.
9. While ensuring that the cables are not damaged, slide the hard drive tray into the
chassis until the spring-loaded latch clicks into place.
Chapter 7 Removing and Replacing Storage Devices 7-9