Sun Microsystems Sun Blade 150 Service Manual page 215

H
hard drive
disabling power management, D–1
identifying model, 4–7
primary data cable, 6–6
primary, removal, 7–6
probe-IDE diagnostic
CD-ROM
probe-IDE diagnostic
secondary IDE cable, 6–7
secondary, installing, 7–8
troubleshooting, 4–2
hard drive address, 4–3
Hard drive cabling configuration, A–4
heatsink
removal, 8–1
how this book is organized, 1–xxi
I
I/O
connector, 1–6
functional descriptions, C–7
OpenBoot diagnostics, 4–8
supported monitors, 1–4
Ichip2 ASIC
functional description, C–7
IDE
PCI IDE controller functional description, C–9
IDE cable
primary hard drive, 6–6
secondary hard drive, 6–7
IDE diagnostics, 4–7
IEEE 1394
functional description, C–11
initializing POST, 3–5
internal drives identification, 4–3
interrupt interface
CPU, C–25
J
jumper settings
CD-ROM and DVD-ROM, A–5
flash PROM, 8–15
jumpers
configurable, C–5
motherboard diagram, C–3
K
key commands
and non-USB keyboards, 10–1
and USB keyboards, 10–2
keyboard
, 4–7
and power levels, C–26
USB connector signal descriptions, B–4
USB information, E–1
L
lithium battery safety, 5–4
loopback test
watch-net, 4–6
M
microphone
functional description, C–9
signal descriptions, B–14
modem set-up, A–7
modem switch settings, A–9
modifying system and safety, 5–2
monitor
setting default display, D–2
monitors, supported, 1–4
motherboard
block diagram, C–3
initializing POST, 3–28
removal, 8–12
motherboard POST, 3–28
mouse
and power levels, C–26
USB connector signal descriptions, B–4
USB information, E–2
multiple and USB, E–1
multiple mouse devices and USB, E–2
N
network diagnostics, 4–6
non-USB keyboards
and OpenBoot commands, 10–1
Index-3