Figure 7-1 Removing And Replacing The Peripheral Assembly - Sun Microsystems Sun Blade 150 Service Manual

4. Disconnect the following:
Smart card reader power cable
I
Diskette drive power cable
I
Diskette drive data cable
I
5. Using a No. 2 Phillips screwdriver, loosen (but do not remove) the three screws
securing the peripheral assembly to the chassis (
Note – Do not remove the three screws securing the peripheral assembly to the
chassis.
Peripheral assembly
FIGURE 7-1
6. Slide the peripheral assembly to the rear of the chassis and lift it from the chassis.
7. Using a No. 2 Phillips screwdriver, remove the three screws securing the diskette
drive to the peripheral assembly.
8. Remove the diskette drive from the peripheral assembly (
7-2 Sun Blade 150 Service Manual • June 2002
Removing and Replacing the Peripheral Assembly
).
FIGURE 7-1
).
FIGURE 7-2