Mounting To A Flat Surface; Figure 56. Adjustable Mount's Back Plate - quanergy M8 User Manual

Mounting to a Flat Surface

Mount the Adjustable Mount (Figure 53) to a flat surface such as a wall, as follows:
1. Unscrew and remove the pole clamp (Figure 55) from behind the Adjustable Mount's
back plate.
2. Prepare the installation site:
• Identify where you want to install the Adjustable Mount.
• Mark and drill holes where needed, as indicated by the mounting holes in the back
8
plate and dimensions in Figure 56.
3. Attach the Adjustable Mount's back plate to the surface using your preferred
fastening hardware and the previously drilled holes.
D
C
161
B
A
8
7

Figure 56. Adjustable Mount's Back Plate

7
M8 Sensor User Guide, QPN 96-00001 Rev K
6
M6 HOLES
50 MOUNTING PATTERN
95.5
6
5 4
REV
SCREW SIZE RECOMENDED TOR
M5
M6
M8
140
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
QUANERGY SYSTEMS INC. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
QUANERGY SYSTEMS INC IS
PROHIBITED.
5 4
Page 82
3
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MM
TOLERANCES:
DECIMALS ANGLES
.X = .25 .5 DEGREES
.XX = .10
.XXX = .05
THIRD ANGLE PROJECTION
MATERIAL
SEE NOTE
FINISH
SEE NOTE
DO NOT SCALE DRAWING
3