Compliances; Astm G154; Ce Compliance; Fcc Compliance - quanergy M8 User Manual

Compliances

Quanergy's M8 LiDAR sensor has been tested and found to comply with the standards and
specifications of several organizations.

ASTM G154

This product complies with standard practices for operating fluorescent Ultraviolet (UV)
lamp apparatus in the exposure of nonmetallic materials. Tests reproduced and measured
the weathering effects that occur when materials are exposed to sunlight, either directly or
through window glass.

CE Compliance

This product complies with the essential requirements of the relevant European health,
safety, and environmental protection legislation as stated in the Harmonized Standards,
which are the technical specifications established by European standards agencies,
including CEN and CENELEC.

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules: FCC Part 15B/ICES-003/EN 61326-1 Class B
testing and report. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FDA Compliance

The M8 LiDAR sensor is designated Class 1
(eye safe) during all procedures of operation,
having satisfied IEC AEL and MPE emission
requirements per IEC 60825-1 8.4F and 13.3.
Complies with US FDA performance standards for
laser products except for deviations pursuant to
Laser Notice No. 50, dated June 24, 2007. CLASS 1
LASER PRODUCT EN/IEC 60825-1 Ed 3 2014, E.U. &
JAPAN IEC 60825-1 Ed 2 2007 USA .
M8 Sensor User Guide, QPN 96-00001 Rev K Page 12