Figure 25. Creating A Network On Windows 7 Machine - quanergy M8 User Manual

• If you attached the sensor to a Windows 7 host machine, refer to Figure 25, then:
– Open the Control Panel item, and select the Network and Internet item, then the Network
Connection item.
– In the Network Connections window, select the Local Area Connection tab.
– In the Local Area Connection Properties dialog box, select the Networking tab, and click
the Configure button.
– In the Internet Protocol Version 4 (TCP/IPv4) Properties dialog box, fill in the values as
follows to make sure the sensor and the Windows 7 host machine share the
same local area network gateway, such as the 192.168.1:
– Select the Use the following IP address radio button.
– In the IP address field, type a static address for the computer, with the shared
gateway (e.g., 192.168.1) and a host address that is any number from 2-254 that
is available, that is, does not conflict.
– In the Subnet mask field, type the subnet that both computer and sensor are on.
– In the Default gateway field, after the shared gateway (e.g., 192.168.1), the last field
is typically 1.
– Select the OK button to apply the changes and close the dialog box.
– In the Local Area Connection Properties dialog box, select the OK button to close the box.

Figure 25. Creating a Network on Windows 7 Machine

M8 Sensor User Guide, QPN 96-00001 Rev K Page 41