Configure The Gps Settings; Figure 48. Normal Alignment: Positive Pps (Top), Active Low Nmea (Bottom); Figure 49. Web Server: Gps Settings - quanergy M8 User Manual

Configure the GPS Settings

The PPS signal from the GPS aligns with the NMEA signal as shown in Figure 48, where the
PPS is active high and universal asynchronous receiver/transmitter (UART) is active low.

Figure 48. Normal Alignment: Positive PPS (top), Active Low NMEA (bottom)

However, the M8 Sensor Settings Management (web server) user interface allows you
to make some decisions (Figure 49) relative to those signals, as discussed in the "GPS
Settings" section on page 49, and as follows.

Figure 49. Web Server: GPS Settings

M8 Sensor User Guide, QPN 96-00001 Rev K Page 73