Connectors And Pins; Figure 14. Sensor Cable M19 (Left), Interface M19 (Center), Interface Sub-Cables (Right); Figure 15. Sensor Cable Connector Wire Color (Left), J1/J2/Sub-Cable Connectivity (Right) - quanergy M8 User Manual

Connectors and Pins

The sensor is permanently attached to a 3-foot sensor cable, which features an M19 IP67-
rated dust- and water-proof connector (Figure 14 left). This connector attaches to an
interface cable, which can be purchased from Quanergy or constructed by the user. Refer
to the photo of the specialized interface cable available from Quanergy, which has the
female version of the M19 IP67-rated connector on one end (Figure 14 center) and three
sub-cables on the other (Figure 14 right). Recommended connectivity is illustrated in the
wire color chart in Figure 15, with pin assignments shown in Figure 16 and Figure 17.
RJ45
J1 Male
Power
NMEA/PPS/Ground
J2 Female

Figure 14. Sensor Cable M19 (left), Interface M19 (center), Interface Sub-Cables (right)

Interface Cable
Sensor Cable

Figure 15. Sensor Cable Connector Wire Color (left), J1/J2/Sub-Cable Connectivity (right)

M8 Sensor User Guide, QPN 96-00001 Rev K Page 27