Low Power Spinup; Table 9. Web Server: Scan Field Specifications Based On Sensor Placement - quanergy M8 User Manual

Table 9. Web Server: Scan Field Specifications Based on Sensor Placement

Mounted
on Car Roof
Scan Field Width
in Degrees:
360.0
Scan Field
Center Angle:
0.0
Scan Field is the Blue Area
When Looking Down
on the Sensor:

Low Power Spinup

The Low Power Spinup parameter applies to M8 Rev D5 and up, as well as to M8 Rev D4 with
patch updating Base firmware to 7.03. When enabled, this option uses less torque during
startup and delays turning on the lasers until the turret has reached the desired speed,
saving about 2 watts from the peak startup power. As a consequence, when compared to
normal startup, the point cloud's appearance may be delayed by as much as an additional
15 seconds.
The Low Power Spinup field is unchecked by default, as shown in Figure 29 (top).
1. Check this box if you prefer to save power during spinup.
2. Click the Submit button, or continue making changes in the next section.
Mounted
to Wall
200.0
0.0
M8 Sensor User Guide, QPN 96-00001 Rev K
Mounted
on Drone
45.0
45.0
Page 47