Mounting The Sensor; Figure 7. Permanent Mounting Base (Round), Detachable Base Plate (Rectangular) - quanergy M8 User Manual

3. Mounting the Sensor

The M8 sensor includes the hardware that allows a user to attach it to a preferred surface.
The mounting assembly is illustrated in Figure 7. The sensor arrives from the factory
securely attached to a round mounting base that must remain attached. Its four M3 threaded
holes are used to mount securely to a surface. A detachable, rectangular base plate is
screwed into the four holes of the round mounting base. The rectangular base plate
provides a platform for the sensor and dissipates heat produced by the sensor's electronics
and motor. It must remain attached unless exchanged for an equivalent heat sink. The
operating temperature range is –20°C to +60°C (–4°F to +140°F).
Customers who remove the detachable base plate (400g aluminum) must substitute a heat sink of
similar or greater thermal mass to prevent the sensor from overheating and to enhance its longevity.
8
D
SENSOR WINDOW
C
POWER CABLE
MOUNTING BASE
B
Do NOT adjust the six
factory-set screws. (Four
A
are concealed by labels.)

Figure 7. Permanent Mounting Base (round), Detachable Base Plate (rectangular)

8
7 6
89.0
C
L
103.0
51.60
7 6
M8 Sensor User Guide, QPN 96-00001 Rev K
5
REFERENCE CENTER
REFERENCE CENTER
3.20°
(CLEARVIEW)
18.25° 22.50
52.70
M5 TAP 5.0mm DEEP 4X
(mounting option)
51.60
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
QUANERGY SYSTEMS INC. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
QUANERGY SYSTEMS INC IS
PROHIBITED.
5
4 3
NOTE: Dimensions are in mm unless
otherwise stated.
Also see Appendix 2.
One 1/4-20 hole for standard tripod.
45.00
FOR REFERENCE O
UNLESS OTHERWISE SPECIFIED:
Four M3 threaded holes
DIMENSIONS ARE IN MM
DRAWN
TOLERANCES:
DECIMALS ANGLES
for mounting the base plate.
CHECKED
.X = .25 .5 DEGREES
.XX = .10
ENG APPR.
.XXX = .05
MFG APPR.
THIRD ANGLE PROJECTION
Q.A.
COMMENTS:
MATERIAL
FINISH
DO NOT SCALE DRAWING
4 3
2
NAME DATE
TITLE:
M8 revis
MECHAN
SIZE DWG. NO.
B
SCALE: 1:2
2
Page 22