Getting Started; M8 Sensor; Figure 1. Sensor Manufacturing Labels; Table 1. M8 Sensor - quanergy M8 User Manual

1. Getting Started

The M8 sensor does not operate on its own; it requires a complete system involving
additional parts to operate and collect data, as explained in the following subsections.
This manual assumes the user will purchase those parts from Quanergy and/or assemble
their own for a complete working system.

M8 Sensor

The M8 sensor includes all hardware listed in Table 1, plus two documents: M8 Sensor
Quick Start Card (https://quanergy.desk.com/customer/portal/articles/2687032) and the
Documents list (https://quanergy.desk.com/customer/portal/articles/2725667) of links to
additional Quanergy user guides. If any expected item is missing or damaged upon arrival,
contact your support representative.
Item
M8 sensor
Detachable rectangular base plate, which arrives pre-attached to the
sensor with four screws
3-foot sensor cable; one end is permanently wired to the sensor, and
the other end is the M19 IP67-rated dust- and water-proof connector
(pin assignments are discussed on pages 27-28)
IP67-rated M19 Female connector if needed to assemble a custom
interface cable (pin assignments are discussed on pages 27-28)
Manufacturing label, which
combines three labels (including
model Core/Plus/Ultra, revision, and
serial number), as shown in Figure 1:
• Manufacturer Label
• Explanatory Label
• Certification Label

Table 1. M8 Sensor

Figure 1. Sensor Manufacturing Labels

M8 Sensor User Guide, QPN 96-00001 Rev K
Image
Page 14