Nameplate, Connections - Endress+Hauser Proline Prosonic Flow 90 Operating Instructions Manual

Proline Prosonic Flow 90
Endress+Hauser
2.1.4

Nameplate, connections

See operating manual
Betriebsanleitung beachten
Observer manuel d'instruction
12345678912
1
Ser.No.:
Supply /
Versorgung /
4
Tension d'alimentation
I-OUT (HART)
f-OUT
5
STATUS-OUT
STATUS-IN
ex-works
6
Device SW:
7 Communication:
8 Revision:
9 Date: DD.MMM.YYYY
Fig. 4: Nameplate specifications for Proline transmitter (example)
1 Serial number
2 Possible configuration of current output
3 Possible configuration of relay contacts
4 Terminal assignment, cable for power supply: 85...260 V AC, 20...55 V AC, 16...62 V DC
Terminal No. 1: L1 for AC, L+ for DC
Terminal No. 2: N for AC, L- for DC
5 Signals present at inputs and outputs, possible configuration and terminal assignment (20...27),
see also "Electrical values of inputs/outputs"
6 Version of device software currently installed
7 Installed communication type, e.g.: HART, PROFIBUS PA, etc.
8 Information on current communication software (Device Revision and Device Description), e.g.:
Dev. 01 / DD 01 for HART
9 Date of installation
10 Current updates to data specified in points 6 to 9
A:
P:
NO:
NC:
L1/L+
N/L-
PE
Active: 0/4...20mA, RL max. = 700 Ohm
Passive: 4...20mA, max. 30VDC, Ri < 150 Ohm
(HART: RL.min. = 250 OHM)
fmax = 1kHz
Passive: 30VDC, 250mA
Passive: 30VDC, 250mA
3...30VDC, Ri = 5kOhm
Update 1
Version info
XX.XX.XX
XXXXXXXXXX
XX.XX.XX
319475-00XX
2 Identification
active
passive
normally open contact
normally closed contact
1 2
P
X
X
Update 2
10
2
3
A
A0000963
11