Endress+Hauser Proline Prosonic Flow 90 Operating Instructions Manual page 33

Proline Prosonic Flow 90
"
Endress+Hauser
Panel mounting
1. Prepare the installation opening in the panel (Fig. 31).
2. Slide the housing through the front of the panel cutout.
3. Screw the fasteners to the wall-mount housing.
4. Screw the threaded rods into the brackets and tighten until the housing is firmly fixed to the
panel wall. Tighten the counter nuts. No further support is necessary.
Fig. 31: Panel mounting (wall-mount housing)
Pipe mounting
Installation according to the instructions in Fig. 32.
Caution!
If a warm pipe is used for the installation, ensure that the housing temperature does not exceed the
max. permitted value of +60 °C.
Fig. 32: Pipe mounting (wall-mount housing)
3 Installation
A0001131
A0001132
33