Inlet And Outlet Runs (Insertion Version); Connecting Cable Length - Endress+Hauser Proline Prosonic Flow 90 Operating Instructions Manual

3 Installation
"
16
3.2.5

Inlet and outlet runs (Insertion version)

If possible, install the sensor well clear of assemblies such as valves, T-pieces, elbows, etc. The long-
est inlet or outlet run must always be taken into account if several flow obstructions are built in.
Compliance with the following requirements for the inlet and outlet runs is recommended to ensure
measuring accuracy.
1
2
3
Fig. 9: Inlet and outlet runs (Insertion version)
1 = Valve; 2 = Pump; 3 = Two pipe bends in different directions
Data above the dimension line: apply to the single path version
Data below the dimension line: apply to the dual path version
3.2.6

Connecting cable length

Shielded cables are offered in the following lengths:
5 m, 10 m, 15 m and 30 m
Caution!
Route the cable well clear of electrical machines and switching elements.
³ 15 x DN ³ 5 x DN
³ 5 x DN
³ 10 x DN
³ 40 x DN
³ 40 x DN
³ 20 x DN
³ 15 x DN
³ 40 x DN
³ 20 x DN
Proline Prosonic Flow 90
A0001107
Endress+Hauser