Table of Contents
Advertisement
100i / 200i / 300i / 400i
Code
Message
Gas Control communication
301/302
or reply fault
Gas Supply Pressure out of
303
range.
304
Gas Control Purging
305
Gas Control protocol error
306
Not used
Gas Control sequencing
307
error
308
Gas Control Type Mismatch
309
Gas Control command fault
310 *
Gas Control Unit fault
Gas Control Unit valve
311 *
control fault
312 *
Gas Selection Console fault Check Gas Selection Console status indicator for specific problem
Gas Controller not config-
313 *
ured.
* Applies to Automatic Gas Control 3000 (Auto Gas) only
42
CCM Status Code
Group 3 -- Gas Controller Status & Protocol
Problem with fiber optic cable to Gas Selection Console or Gas Control Unit; Dirt
on fiber ends or in connectors; blow out with clean dry air. Fiber not locked into
connector; Sharp bends in fiber cable; Fiber defective; Gas Selection Console or
Gas Control Unit power supply defective; Gas Selection Console or Gas Control
Unit circuit board defect
Inlet plasma or shield pressure low or defective pressure sensors PS3 & PS4;
For Automatic Gas Control see Gas Control Unit for pressure faults.
Normal following power up or returning from Plasma Disable. Wait for purge to
finish.
Verify Firmware revision for compatibility with Gas Selection Console and Gas
Control Unit.
Reserved for other future use.
Verify Firmware revision for compatibility with Gas Selection Console and Gas
Control Unit
Wrong CCM for Power Supply; Install correct CCM
Verify Firmware revision for compatibility with Gas Selection Console and Gas
Control Unit; Electromagnetic interference with Arc Starter; inspect grounding;
bonding; and isolation
Check Gas Control Unit status indicator for specific problem
Check Gas Control Unit status indicator for specific problem
Gas Selection Console or Gas Control Unit not configured for a process or
locked; See Gas Selection Console and Gas Control Unit status
OPERATION
Remedy / Comments
0560956430
Advertisement
Table of Contents
