Torch Head
7. Slide the ohmic clip over the shield cup if using ohmic torch height sensing.
8. Connect the wire lead from the height finder to the ohmic clip if using ohmic torch height sensing.
0560956430
0.063 - 0.083"
(1.6 - 2.1 mm)
Protrusion
Installing Assembled Cartridge Onto Torch Head
Ohmic Clip
NOTE!
Ohmic height sensing is not recommended with water shield. Water on the
plate interferes electrically with the ohmic sensing circuit.
Art # A-03393_AB
INSTALLATION
100i / 200i / 300i / 400i
Torch Head O-Ring
Art # A-08300_AB
33