10-2 Procedure To Use The Snmp Agent; Procedures; Settings Required For The Snmp Agent - Omron NX-series User Manual

10 SNMP Agent

10-2 Procedure to Use the SNMP Agent

10-2-1

Procedures

(1) Select Built-in EtherNet/IP Port Settings from the Controller Setup.
Make the following settings on the SNMP Settings Display or the SNMP Trap Settings Dis-
play.
• SNMP Service
• Recognition 1
• Recognition 2
(2) Select Transfer to Controller from the Controller Menu and click the Yes Button. The built-in
EtherNet/IP port settings are transferred to the Communication Control Unit.
10-2-2

Settings Required for the SNMP Agent

The following Built-in EtherNet/IP Port Settings are made from the Sysmac Studio to use the SNMP
agent.
Tab page
SNMP Settings
SNMP Trap Settings
10 - 20
Setting
SNMP service
Port No.
Contact, location
Send a recognition trap
Recognition 1 and Recog-
nition 2
IP address
Host name
Community name
SNMP trap
Port No.
Trap 1 and trap 2
IP address
Host name
Community name
Version
NX-series Communication Control Unit Built-in Function User's Manual (Z396)
Setting conditions
Required.
Specified by user.
Required to change from the default value
of 161.
Specified by user.
Specified by user.
Select this check box to send a recogni-
tion trap if there is access from an SNMP
manager that is not specified (Access oth-
er than Recognition 1 and 2).
Specified by user.
Make these settings to permit access by
only certain SNMP managers.
Required
Specified by user.
Required to change from the default value
of 162.
Required
Set an IP address or a host name as the
SNMP trap destination.
Specified by user.
Required
Set the version of the SNMP manager.
Reference
page A - 9
page A - 10
page A - 11
page A - 12