Omron NX-series User Manual page 186

Appendices
l SNMP Trap
Setting
SNMP trap
*2
Port No.
*1. If you specify to use the SNMP trap, you also have to set Trap 1 and Trap 2 as described below.
*2. The following ports are used by the system and cannot be set by the user: 25, 53, 68, 110, 2222, 2223,
2224, 9600, and 44818.
Additional Information
Refer to 10-1-1 Overview on page 10 - 2 for details on the SNMP trap.
l Trap 1
If the Use Option is selected for SNMP trap, you need to make the following settings.
Setting
Recognition method
IP address
Host name
Community name
Version
l Trap 2
If the Use Option is selected for SNMP trap, you need to make the following settings.
Setting
Trap 2
Recognition method
A - 12
Description
Specify whether to use the SNMP trap (network error detec-
*1
tion).
If the Do not use Option is selected for SNMP trap, SNMP traps
are not sent to the SNMP manager
Set the port number to use to connect to the SNMP server.
It is normally not necessary to change this setting.
Description
Set the specifying method for the SNMP manager destination for
SNMP traps.
•
IP address
•
Host name
Set the IP address of the SNMP manager.
(Set this setting if the Recognition method in the Trap 1 settings
is set to the IP address Option.)
Set the host name of the SNMP manager.
(Set this setting if the Recognition method in the Trap 1 settings
is set to the Host name Option.)
(You can use up to 200 single-byte alphanumeric characters,
dots, and hyphens with up to 63 single-byte alphanumeric char-
acters between dots.)
Set the community name.
(You can use up to 255 single-byte alphanumeric characters.)
Set the version of the SNMP manager.
•
SNMPv1
•
SNMPv2C
Description
Specify whether to use the Trap 2 settings.
•
Use
•
Do not use
Set the specifying method for the SNMP manager destination for
SNMP traps.
•
IP address
•
Host name
NX-series Communication Control Unit Built-in Function User's Manual (Z396)
Default
Do not use
162
Default
IP address
None
None
public
SNMPv2C
Default
Do not use
IP address