Omron NX-series User Manual page 121

Parameter name
General Status
Size of Additional Status Size of Additional status
Additional status
*1. If the general status code in the response code is 0x1F (Vendor specific error), the value is 0x01.
*2. The value is stored only when the value of the Size of Additional Status is 0x01.
CIP Error Code
General status code (hex)
02
0C
13
15
1F
20
*1. For details of the individual errors, refer to the appendix of NX-series Safety Control Unit / Communication
Control Unit User's Manual (Cat. No. Z395).
l Clear Event Log (Service Code: 3C hex)
The request format, format for normal responses, format for error responses, and CIP error codes
for the Clear event log object are given below.
Request Format
Parameter name
Service
Request Path Size Size of request path USINT
Request Path
Unit No
Event log type
Format for Normal Response
Parameter name
Reply Service
Reserved
General Status
Size of Additional
Status
Format for Error Response
Parameter name
Reply Service
NX-series Communication Control Unit Built-in Function User's Manual (Z396)
Description
Current error code defined by CIP USINT
Additional status
*1
Error code
Resource unavailable
Object state conflict
Not enough data
Too much data
Vendor specific error
Invalid parameter
Description Data type
Service code USINT
Request path Padded EPATH 20742401
Unit number UINT
Type of event log UINT
Description
Reply to Clear event log serv-
ice
Reserved
Code that indicates normal
Size of Additional status
Description
Reply to Clear event log serv-
ice
8 CIP Message Communications
Data type Value (hex)
Current error code
USINT
*1
00 or 01
UINT
Additional status
Value (hex)
3C
02
0000: Communication Control Unit
0001 to 0020: NX Unit
0021 or higher: Not supported
0000: System event log
0001: Access event log
0002: Not used
0003: Both system event log and access event log
Data type
USINT BC
USINT 00
USINT 00
USINT 00
Data type
USINT BC
*2
Value (hex)
Value (hex)
8 - 25
8