Eeprom Clear All - SATO CL608 Service Manual

7-3 EEPROM Clear All

To reset the printer to the factory settings, perform the following steps.
Caution: Resetting the printer will clear all registers.
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFF
position.
2. Place the DSW2-5 in the ON or up position.
3. Place the print head in the open position. Keeping both the LINE and
FEED keys depressed, power on the printer.
4. Upon hearing the audible tone, release the LINE and FEED keys. Place
the print head back in the closed position and DSW2-5 in the OFF or
down position.
5. Verify display: "FACTORY MODE".
6. Press the FEED button once. Verify display: "COUNTER CLEAR NON".
7. Press the LINE button once. Verify display: "COUNTER CLEAR ALL".
8. Press FEED button to initialize reset. After a slight pause, (2) blank
labels will feed out followed by a factory test print.
9. Press the FEED key to stop printing. Verify that the counters on test print
have reset to 0.0 km.
10. Place the printers power switch to the OFF position and return all
switches to their original positions.
PN 9001024
Rev. B Jan. 2000
SECTION 7 – Factory Resets
Warning: This test activates all the heating elements on
the print head and therefore should be used for testing
purposes only with full width labels to avoid damaging the
print head.
SATO CL608 & CL612 SERVICE MANUAL
FACTORY MODE
COUNTER cLEAR
NON
COUNTER CLEAR
ALL
Page 7-3