Allen-Bradley ArmorStart 290E User Manual page 149

ATTENTION:
Ramp-to-Stop Mode
Stop Command
• If a hazard of injury due to movement of equipment or material exists, an
auxiliary mechanical braking device must be used.
• This feature should not be used with synchronous or permanent magnet
motors. Motors may be demagnetized during braking.
ReverseDisable
O
Stop drive before changing this
parameter.
Enables/disables the function that allows
the direction of the motor rotation to be
changed.
0 = Enabled
1 = Disabled
FlyingStartEn
Sets the condition that allows the drive
to reconnect to a spinning motor
at actual RPM.
0 = Disabled
1 = Enabled
Rockwell Automation Publication 290E-UM001B-EN-P - June 2012
Bulletin 290E/291E/294E Programmable Parameters
DC Injection Braking Mode
Voltage
Speed
[DC Brake Time]
}
[DC Brake Level]
Time
Parameter Number
Related Parameters
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Parameter Number
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Chapter 4
[DC Brake Time]
}
[DC Brake Level]
Time
Stop Command
77
—
GET/SET
UINT
Advanced Config.
—
0
1
0
78
GET/SET
UINT
Advanced Config.
—
0
1
0
149