Allen-Bradley ArmorStart 290E User Manual page 134

Chapter 4 Bulletin 290E/291E/294E Programmable Parameters
MotorOLCurrent
Set to the maximum allowable motor current.
Cat. No.
294_FD1P5
294_FD2P5
294_FD4P2
CurrentLimit
Maximum output current allowed before current limiting occurs
Cat. No.
294_FD1P5
294_FD2P5
294_FD4P2
StopMode
Valid Stop Mode for the Bulletin 294E ArmorStart LT are the following:
0 = RampToStop, "Stop" command clears active fault
1 = Coast to Stop, "Stop" command clears active fault
2 = DCBrake, DC Injection Braking Stop, "Stop" command clears active fault
3 = DCBrakeAuto, DC Injection Stop with Auto Shutoff
Standard DC Injection Braking for value set in Parameter 75 (DC Brake Time)
or
Drive shuts off if current limit is exceeded.
134
Hp (kW) Min Amps
0.5 (0.4) 0
1.0 (0.75) 0
2.0 (1.5) 0
Hp (kW)
0.5 Hp Min = 0; Max = 2.7; Default = 2.2
1.0 Hp Min = 0; Max = 4.5; Default = 3.7
2.0 Hp Min = 0; Max = 7.5; Default = 6.3
Rockwell Automation Publication 290E-UM001B-EN-P - June 2012
Parameter Number
Related Parameter
Access Rule
Data Type
Group
Default Amps Units
1.5 Minimum Value
2.5 Maximum Value
3.6 Default Value
Parameter Number
Related Parameters
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Parameter Number
Related Parameters
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
30
31, 80, 82...83
GET/SET
UINT
Motor and Control
x.x Amps
0
Cat. No. Dependent
Cat. No. Max Output
31
GET/SET
UINT
Motor and Control
x.x Amps
0
Cat. No. Dependent
Cat. No. Dependent
32
GET/SET
UINT
Motor and Control
—
0
3
0