Allen-Bradley ArmorStart 290E User Manual page 147

MotorOLRetention
Enables/disables the Motor overload
Retention function. When Enabled, the
value held in the motor overload counter
is saved at power-down and restored
at power-up. A change to this parameter
setting resets the counter.
0 = Disabled (Default)
1 = Enabled
InternalFreq
Provide the frequency command to drive
when Parameter 33 (Speed-Reference) =
1 (InternalFreq). When enabled, this
parameter will change the frequency
command in real time.
SkipFrequency
Sets the frequency at which the drive will
not operate.
SkipFrqBand
Determines the band width around
Parameter 73 (SkipFrequency). Parameter
74 (SkipFreqBand) is split applying 1/2
above and 1/2 below the actual skip
frequency. A setting of 0.0 disables
this parameter.
Rockwell Automation Publication 290E-UM001B-EN-P - June 2012
Bulletin 290E/291E/294E Programmable Parameters
Parameter Number
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Parameter Number
Related Parameters
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Parameter Number
Related Parameters
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Parameter Number
Related Parameters
Access Rule
Data Type
Group
Units
Minimum Value
Maximum Value
Default Value
Chapter 4
71
GET/SET
UINT
Advanced Config.
—
0
1
0
72
33
GET/SET
UINT
Advanced Config.
x.x Hz
0.0
400.0
60.0
73
74
GET/SET
UINT
Advanced Config.
Hz
0
400 Hz
0 Hz
74
73
GET/SET
UINT
Advanced Config.
x.x Hz
0.0 Hz
30.0 Hz
0.0 Hz
147