Allen-Bradley ArmorStart 290E User Manual page 221

Table 34 - Fault Codes, Fault Text, and Fault Help Strings for Drive Units
Fault
Code Fault Text
5 Phase U to Gnd
6 Phase V to Gnd
7 Phase W to Gnd
8 Phase UV Short
9 Phase UW Short
10 Phase VW Short
11 Ground Fault
12 Stall Trip
13 Switched Power
14 Under Power Trip
15 Sensor Short
16 Output Short
17 Fault 17
18 Heatsink Temp
19 HW Over Current
20 SW OverCurrent
21 Aux Power Loss
22 Internal Comm
23 Drive Comm Loss
24 Power Loss
25 Under Voltage
26 Over Voltage
27 MCB EEPROM
28 Param Sync
29 Drive EEPROM
30 Hardware Fault
31 Fan RMP
32 Power Unit
33 Drive I/O Brd
34 Restart Retries
35 Drive Aux In Flt
36 Fault 36
37 Drv Param Reset
38 Fault 38
39 Fault 39
40 Unknown Fault
Rockwell Automation Publication 290E-UM001B-EN-P - June 2012
Help Text
A Phase U to Ground fault detected between drive and motor.
A Phase V to Ground fault detected between drive and motor.
A Phase W to Ground fault detected between drive and motor.
Excessive current detected between phases U and V.
Excessive current detected between phases U and W.
Excessive current detected between phases V and W.
A current path to earth ground at one or more output terminals.
The drive is unable to accelerate the motor.
Indicates the loss of switched control power.
Not available in units with Integrated Power Supply
Indicates the internal power supply is below its working level.
Available in units with Integrated Power Supply only.
Flags a miswired hardware input point.
Flags a miswired hardware output point.
The Heatsink temperature exceeds a predefined value.
The drive output current has exceeded the hardware limit.
Programmed parameter 83 (SW Current Trip) has been exceeded.
Auxiliary Power was lost or dipped below the minimum threshold.
Not available in units with Integrated Power Supply.
Communication with the internal Power Flex drive has been lost.
The RS485 port on the internal Power Flex stopped communicating.
Drive DC Bus Voltage remained below 85% of nominal bus voltage.
DC Bus Voltage fell below the minimum value.
DC Bus Voltage exceeded the maximum value.
This is a major fault which renders the ArmorStart inoperable.
The drive and Main Control Board EEPROMS are not in sync.
The drive EEPROM checksum checks have failed.
This is a major fault which renders the unit inoperable
The internal cooling fan is not running properly.
A major failure has been detected in the drive power section.
A failure has been detected in the drive control and I/O section.
Automatic fault reset and run retries exceeded.
The drive auxiliary input interlock is open inside the ArmorStart.
—
Internal Drive Parameters (Parameters > 100) have been defaulted.
—
—
—
CIP Information Appendix B
PF4M
Fault
Code
38
39
40
41
42
43
13
6
8
12
63
71
81
3
4
5
100
70
122
33
2
48
221