Table of Contents
Advertisement
C C h h a a p p t t e e r r 4 4 I I n n s s t t a a l l l l a a t t i i o o n n
4 4 . . 1 1
P P r r e e l l i i m m i i n n a a r r y y I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
Installation should be performed only by qualified personnel knowledgeable of batteries and the required
precautions.
Observe these precautions while installing the Integrated Battery Cabinet (IBC):
•
Remove watches, rings, or other metal objects.
•
Use tools with insulated handles.
•
Wear voltage rated gloves and electrical hazard footwear.
•
Do not lay tools or metal parts on top of batteries or battery cabinets.
•
Review Chapter 3 Installation Plan and Unpacking for cabinet dimensions, equipment weight, wiring
and terminal data, and installation notes.
4 4 . . 2 2
U U n n l l o o a a d d i i n n g g t t h h e e I I B B C C C C a a b b i i n n e e t t f f r r o o m m t t h h e e P P a a l l l l e e t t
•
The IBC is heavy (see
•
RISK OF INSTABILITY. Do not remove any internal panels until the cabinet is removed from and lowered
from the pallet.
•
Do not tilt cabinet more than 10° from vertical.
•
Lift the cabinets only with a forklift or pallet jack or damage may occur.
•
Ensure forklift is rated to handle the weight of the cabinet.
Failure to follow these instructions may result in severe injury or death.
The IBC is bolted to a pallet consisting of two metal angle supports and two flat supports secured to two wood
supports.
To remove the pallet:
Do not use the jacking bolts on a soft surface floor. Use only on a hard surface, such as concrete. If necessary
remove pallet on a hard surface and roll cabinet to final installation position.
1.
If not already accomplished, use a forklift or pallet jack to move the IBC to the installation area, or as close
as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the supports on
the bottom of the pallet (see
2.
Open the front door by lifting the latch from the bottom and turning to the right (counterclockwise) and
swing the door open.
Eaton 93PM Integrated Battery Cabinet (IBC-L, IBC-LH [432V], and IBC-LH [480V]) Installation Manual 164000228—Rev 08
Table 1
NOTE
For the following procedures, verify that the forklift or pallet jack is rated to handle the
weight of the cabinet (see
Figure 8
WARNING
WARNING
through
Table 3
for cabinet weight).
Table 1
through
CAUTION
or
Figure 9
for the IBC cabinet center of gravity measurements).
Table 3
for cabinet weight).
33
Advertisement
Table of Contents
