Result on the isometric drawing
8.8
"Fastening table" tab
8.8.1
General information
This tab is only available for COMOS pipe specs.
On the "Fastening table" tab, you determine the combinations for attachment types for certain
connection types.
8.8.2
Configuring the fastening table
The table is composed of the values that have been selected at the pipe part in use on the
"Attributes > Connector <1-n>" tab, "Attachment type" list.
Requirement
● You have drawn pipe parts with fastening connectors onto the "Pipe parts" tab.
Connections: "CM<counter>"
Example: Pipe with flange
● You have drawn fastening parts onto the "Pipe parts" tab.
● You have opened the "Fastening table" tab.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
Configuring pipe specs
8.8 "Fastening table" tab
105