Creating A Revision Of Pipe Specs - Siemens COMOS Operating Manual

Creating a revision of pipe specs

After you have assembled the pipe spec and assigned all required pipe parts to the pipe spec,
you can change the properties of the pipe parts at a later time. You can do this by inheritance,
for example, if attributes of a pipe part are changed in the pipe part catalog.
To prevent that a pipe part changes in a pipe spec at a later time, you can create a revision of
the pipe spec and its pipe parts. This revision stores all properties of the pipe parts that were
present when the pipe class was created.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
10
119