Adding P&Id Function Codes - Siemens COMOS Operating Manual

P&ID 3D pipe part catalog interaction
11.4 Adding P&ID function codes
3. Project properties: Configure the following categories:
– "Process engineering > PipeSpec Manager"
– "Process engineering > PipeSpec Designer"
See Configuring project properties for P&ID catalog and pipe part catalog interaction
(Page 126).
4. Configure the properties of the P&ID base objects. See Configuring P&ID base objects
(Page 127).
Configure the properties of the pipe part catalog base objects. See Configuring pipe part
catalog base objects (Page 129).
11.4 Adding P&ID function codes
Every entry in the standard table represents a P&ID component category. The entry defines
the function code of the component category. You can enter as many component categories
as you like in the standard table.
Requirements
● The base project is open.
● The standard table containing the P&ID function codes is open.
"Standard tables > @40 > Y00 > A10 > A90 > Y00N00217 Function code for P&ID"
Procedure
1. Create a new standard table entry.
2. "Name" property: Enter the name of the component category.
3. "Description" property: Enter the description of the component category.
4. "Value 1" property: Enter the abbreviation of the component category.
– The ID code is used as a link code in the standard table for function codes. In other
– You can work with the following placeholder characters: "*"
Example for P&ID function code with placeholders
Abbreviation in the standard table for P&ID function codes: "V2W***"
All entries in the standard table for function codes whose link code in the "Value 2" column is
six characters in length and starts with "V2W" count as hits (for example: " V2WARM",
"V2WSVA", "V2WORI").
124
words, COMOS searches the standard table for function codes using the ID code.
COMOS then searches the standard table for function codes with a LIKE comparison.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA