Configuring Pipe Specs; Overview For Configuring Pipe Specs - Siemens COMOS Operating Manual

Configuring pipe specs

8.1

Overview for configuring pipe specs

Requirement
● The general requirements for working with the PipeSpec Designer have been met.
See also chapter Preparing for creation and maintenance of pipe specs (Page 15).
● You have loaded a pipe spec in PipeSpec Designer.
See also chapter Loading a pipe spec in PipeSpec Designer (Page 71).
Workflow
Configure the tabs in the following order:
1. "Pipe spec limits". See chapter Configuring the "PipeSpec limits" tab (Page 80).
2. "Characteristics". See chapter Configuring the "Characteristics" tab (Page 84).
3. "Pipe parts". See chapter Configuring the "Components" tab (Page 87).
4. "Nominal diameters". See chapter "Nominal diameters" tab: (Page 90).
5. "Branch table". See chapter "Branch table" tab (Page 95).
6. "Connector table". See chapter "Connector table" tab (Page 100).
7. "Fastening table": See chapter "Fastening table" tab (Page 105).
8. If required: "Comments".
Displaying a tab in an additional window
"Pipe parts" button:
Use this button to display a tab of the PipeSpec Designer in an additional window. The
additional window does not have any extra functions, but serves to simplify the configuration
of the tabs.
Previously configured tabs
● "Diagram":
The PipeSpec Designer evaluates data configured at the pipe components and displays it
on the tab. A configuration is not required.
● "Function":
The tab has already been preconfigured in the database.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
8
79