Configuring The Connector Table - Siemens COMOS Operating Manual

Table for special parts
The table defines the pipe parts for which additional objects are added at the connectors.
Example: Adding flanges at the connectors of a tee.
The table has the following columns:
● "Object":
– The special part at whose connectors additional pipe parts are added.
– It is displayed in the row for the first connector.
● "Connectors":
A row is added to the table for each connector of the pipe part.
● "Extra object":
The component added at this connector.
● "Definition applies":
Determines whether the definition is to be valid only for the pipe part drawn in the table or
for a certain function code range.
Possible values:
– "For current object": What matters here is not the function code, but the SystemUID of
– "71100" to "71XXX": The function code ranges
Only available in the row in which the "Object" is set.
8.7.2

Configuring the connector table

Requirement
● Observing the workflow for configuration of pipe specs. See also chapter Overview for
configuring pipe specs (Page 79).
● You have assigned the following pipe spec elements to the pipe spec on the "Pipe parts"
tab:
– The pipe parts to be connected.
– The connecting parts to be placed between the pipe parts.
● You have opened the "Connector table" tab and are working in the "Connector table" area
of the tab.
Procedure
1. Open the context menu in the cell for the connection type combination and select "Edit (F2)".
A list of pipe spec elements whose connection type matches on at least one side is
displayed.
2. Select a suitable pipe spec element.
3. Save your entries.
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
the base object.
Configuring pipe specs
8.7 "Connector table" tab
101