Preparing for creation and maintenance of pipe specs
3.8 Preparing bolt sets
Standard table for screw lengths
● Standard tables in the database:
– DIN/EN:
– ANSI/ASME
Similar to the standard table for nominal diameters, the following applies:
– New values are appended to the end of the list.
– Do not move or delete existing entries.
● The standard table is used in the following places:
– In the "standard geometry tables" standard catalog
– At the bolts, nuts, and washers in the pipe part catalog.
Standard table of strength grades for screws and nuts
● Standard table in the database:
– DIN/EN:
–
● The standard table is used in the following places:
– In the PipeSpec Designer on the "Characteristics" tab.
– In the properties of screws and nuts, "Attributes > Part description" tab.
Standard table for bolted types
● Standard table in the database:
"Standard tables > Y10 > M23 > A20 > Y10M23N00028 Bolted types"
● The standard table is used in the flanges of the pipe part catalog, on the "3D geometry" tab.
68
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A20 Bolt length"
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A20 Bolt length"
"@30 > M23 > A10 > Y30 > A10 Standard geometry tables"
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A30 Strength grade bolts acc
DIN2507"
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A40 Strength grade nuts acc
ISO 898-2"
ANSI/ASME:
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A30 Property classes of bolts
according to ASME"
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A40 Property classes of nuts
according to ASME"
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA