Structure Of The Standard Catalog For Geometry Standards; Structure Parameters - Siemens COMOS Operating Manual

3.4.2

Structure of the standard catalog for geometry standards

The standard catalog is based on a template that determines the structure of the catalog.
● The templates of the standard geometry tables can be found under the following node:
"@10 > A20 > A20 > A20 > A10 Geometry tables"
● The preconfigured standard geometry tables can be found under the following node:
"@30 > M23 > A10 > Y30 > A10 Standard geometry tables"
Features of the "standard geometry standards" catalog
The "standard geometry standards" catalog comprises two types of object:
● Structure objects: The nodes in the Navigator tree
They structure the catalog, based on is structure parameters.
● Geometry tables: The tables in the Navigator tree
They save the dimensions of the pipe parts.
3.4.2.1

Structure parameters

Overview
The following parameters structure the standard catalog:
● System of standards (DIN, EN, ANSI, etc.)
● Flange standard system (DIN, EN, ANSI, etc.)
● Connection types
● Part types such as certain flanges, reducers, etc.
● Construction types such as various elbow radii, etc.
● Nominal pressure level
See also
Extending the "Standard parameterization table" (Page 23)
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
Preparing for creation and maintenance of pipe specs
3.4 Managing the "standard geometry tables" standard catalog
21