Siemens COMOS Operating Manual page 97

You have the following options to determine the branch parts:
● Assigning a branch part to each individual nominal diameter combination
● Assigning the same branch part to several nominal diameter combinations at once
● Applying the preselected components set on the "Nominal diameters" tab for all nominal
diameter combinations
● Not assigning a branch part so that the default preselected component is used
● Using the option in the "Branch parts" column on the "Pipe parts" tab.
Requirement
● Observing the workflow for configuration of pipe specs. See also chapter Overview for
configuring pipe specs (Page 79).
● Branch parts were assigned to the pipe spec.
● You have opened the "Branch table" tab.
● Display mode is "Only show preselected components".
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
Configuring pipe specs
8.6 "Branch table" tab
97