Siemens COMOS Operating Manual page 67

Standard table of standards for screws and nuts
● Standard tables in the database:
– DIN/EN:
– ANSI/ASME:
– "Standard tables > Y10 > M20 > Y30 > A10 > 10 > B10 > B40 Screw standards"
● The standard table is used in the following places:
– As a parameter in the standardizations, on the "Attributes > Define characteristics" tab.
– In the properties of screws and nuts, "Attributes > Part description" tab.
Standard table of dimensions of screws and nuts
● Standard tables in the database:
– DIN/EN:
– ANSI/ASME:
● Similar to the standard table for nominal diameters, the following applies:
– New dimensions are appended to the end of the list.
– Do not move or delete existing entries.
● The standard table is used in the following places:
– In the "standard geometry tables" standard catalog.
– At the bolts, nuts, and washers in the template of the pipe part catalog under the following
PipeSpec Designer
Operating Manual, 09/2014, A5E32076948-AA
"Standard tables > Y10 > M20 > Y30 > A10 >1 > B10 > B40 Screw standards"
"Standard tables > Y10 > M20 > Y30 > A10 > 1 > B40 > A10 Bolt dimensions nuts and
bolts"
"Standard tables > Y10 > M20 > Y30 > A10 > 10 > B40 > A10 Bolt dimensions"
node:
"@30 > M23 > A50 > A10 > Pipe part Catalog template"
Preparing for creation and maintenance of pipe specs
3.8 Preparing bolt sets
67